Option: Instead of tying the fringe, make a small slit in each fringe, near the top.
Make sure you do this to both layers. The slit should only be 1/8" - 1/4" big.
Now,take the tip of the top fringe and pull it through the slit in the botton fringe. pull it far enought you can see the slit in the top fringe. Pull the bottom finge through. Do that to every fringe.

Looped (Mary Ann Overturf)

Cut out 3" squares from each corner of fleece after removing the selvedge edges.

Place a strip of masking tape 3" from the edge of the fleece on all four sides.

Turn up the edge of the fleece to meet the masking tape.

Pin & sew the raw edge using a zigzag stitch.

Cut the fringe in 1/2" strips stopping the cut 1/4" from the stitching.

*Optional: After cutting the loops, make a braided edge by "finger crocheting" one loop through the next loop. Go all the way around the blanket using a large crochet hook to pull the loops through. Tuck the last loop into the first one and hand stitch to anchor.

Another option for the Looped Finish is to sew a 3" piece of contrasting or coordinating fleece to each end of the blanket. Fold in half, sew down with a zigzag stitch and cut the loops as above.

Skip-Stitch Rotary Blade Instructions

1) Cut fleece rectangle removing selvages. 2) Position ruler lengthwise ** from edge of fleece. 3) Using a 45mm rotary cutter equipped with the Skip-Stitch blade, run cutter along edge of ruler with enough pressure to perforate the fleece. 4) Mark last perforation with a pin. Reposition ruler to continue cutting. Place a blade tooth in the last perforation and continue cutting to end of the side. Repeat for each side of your project.

IMPORTANT * Run blade over each area only once. A second cutting will result in an unusable edge.

5) Crochet the Foundation Pattern around your project turning the edge under as you go. This alone makes an attractive finish or, if desired, you may then add the edging pattern of your choice. Trimming a small triangle from each corner before beginning to crochet keeps the underside of the corner neater.

Foundation Pattern With right side of fleece facing you, single crochet in any hole but corner hole, chain l, single crochet in next hole, chain l. Continue around blanket, working 3 single crochets in corner holes.

A suggested finishing pattern. 1) From the front side of your project, slip-stitch in a back loop of a stitch on the foundation pattern. 2) Skip a loop and work 3 double-crochets in the next loop, 3) Skip a loop and slip-stitch in the next loop. 4) Repeat steps 2 and 3 until you reach the second hole from the corner. Continue the same pattern without skipping any loops until you reach the second hole on the other side of the corner. 5) Then, continue skipping loops as before until you reach the second hole from the next corner. NOTE * As you finish a round you will probably have to adjust your stitches to make the final joining of the pattern blend in attractively.

A variety of lovely blankets can be created by joining panels of fleece.

Example 1. Position panels back to back. Using a tapestry needle and yarn, whip-stitch panels together through outside loops of foundation stitching. Weave in yarn end

Example 2. This joining is achieved by positioning the panels back to back and joining outside loops with a slip-stitch using a crochet needle. Weave in yarn ends.